How to Run Ethernet Cable Along a Wall: The Simplest, Easiest Tutorial

If you want to set up an Ethernet cable in your home, you’ll need to run it through the wall. Luckily, this is easier than you may think! We’ve put together a step-by-step tutorial on how to run an Ethernet cable along a wall. All you need is two electric drills and some supplies. Read on for all the details!

Tools and Materials

The tools and materials you need to run an Ethernet cable through a wall are pretty simple. You’ll need two electric drills—one for the drill bit, the other for driving screws. You’ll also need some Ethernet cable; make sure you get enough of it! The length depends on how long you want the Ethernet cord to be. You’ll also need a masonry drill bit, insulation tape, plastic plugs, and drywall anchors.

Run Ethernet Cable Along a Wall

Drill Holes in the Wall

When you’re ready to drill holes in your wall, make sure to wear eye protection and follow all safety precautions. Start by drilling a hole at the top of the wall where you want the cable to come out. Drill another hole about halfway up the wall on the other side of where you want your cable to come out (this will be the bottom of your Ethernet connection). Now move down and drill another hole near the bottom of the wall on either side for your cables.

Run the Cables Along s Straight Line

The first thing you want to do is run the cables along a straight line. This will help you have a more professional-looking installation. You can also use a straight edge or a level to help you stay on a straight line. It’s best to measure and mark the wall at intervals so that your cables are evenly spaced.

Once you have your markings, use an electric drill to create holes for the cables in the middle of each marked section of drywall. In order to make sure the holes go all the way through, make sure you drill from both sides of the drywall.

When drilling from behind, it’s important to anchor the drilled hole with screws or push pins before continuing on with drilling from in front. Otherwise, when you drill in front, the drywall will fall into the hole and become loose or even rip completely off of the wall! To finish off your drilled hole, simply cut away any excess drywall using a utility knife and then seal up any gaps with joint compound or spackle before painting over it!

Install the Faceplates

The first thing you’ll need to do is install the faceplates for your Ethernet cables. For this, you’ll need two electric drills. Start by drilling a small hole in the wall. You can use a pencil or pen to mark where you want your holes to be drilled before starting, but it’s more difficult to drill through drywall if you don’t have any holes marking your spot. After drilling the hole, insert the faceplate and secure it tightly with screws. Repeat this process until all of your faceplates are installed.

Conclusion

Now that you know how to do it, you can run the cables and install the faceplates without any problems. The first step is to gather your materials and tools. If you don’t have the tools and materials, you might be able to find them at your local hardware store.

Next, drill holes in the wall. You can use a drill bit size that’s the same as the cable. Make sure to drill holes every 24-inches.

The next step is to run the cables. The cables should be threaded through the drilled holes and then secured with cable ties or wire ties.

Finally, install the faceplates. It’s a good idea to do this before you run the cables because it will make it easier to install the faceplates if you don’t have to worry about running cables at the same time.

You’re now ready to run Ethernet cable along a wall with ease!

Leave a Reply